For example, they are usually sold to hide/camouflage the license plate screws themselves. :D As has been mentioned above, there are a few options that may help some of you: First, you can purchase screw caps that fit over and hide screw heads. Of course the one on the spinning display at the show didnt have the stupid plate on it. I also took some pictures of the BLACK sport at the Miami Beach Car Show last week. Since you have the sport your grill is black too. They promised to remove it and fix it at my first service, but without replacing the front grill, I dont see how they will fill the holes permanently. He literally grabbed me by the shoulder to pull me back out of my car because I was leaving the dealership. I almost kicked the sales manager in the nuts when he said it looked just fine. To make it worse the dealer put a their HUGE YELLOW advert plate on front. In FL we dont have front plates and my black sport came with that horrible piece of junk attached to it. I'll keep my eyes open for any rounded buttons that might fit in there to plug the holes completely The look is a WHOLE lot cleaner than the big plastic holder, so i'm happy. It left two, you guessed it, 7/32' holes in the bumper, but after blackening the inside of the holes with a permanent ink marker, they're hardly noticeable standing a three feet away. I started with small drill bits and worked my way up to a 7/32 and the whole thing fell off.

Wasn't sure if it was a screw with a rear backer or a rivet? Its a rivet. My 2011 Sport came with a big ole' chunk of plastic riveted through the front bumper and I just couldn't see fit to put a license plate up there, so. Yep like the title says, Front License Plate Holder Removal.

Ford edge front license plate bracket